7171-37: 2 of 4; Rev. 5; 07/00
Safco Products Company, New Hope, MN 55428
Unfold the D Back Panel and lay it out flat INSIDE
between the two side panels, with the end having
two holes near each corner toward the BOTTOM of
the unit. Line up the holes in the back panel with
the holes in the steel side panels. Insert E Plastic
Push Fasteners through the TOP holes in each
corner (ONLY) of the back panel, into the holes in
the side panels, and tap the fastener heads gently
with a small hammer or mallet until seated.
Q
Q
Q
Q
Q
3
Q
Q
Q
Q
Q
D
Q
Q
Q
Q
Q
E
TWO HOLES
NO FASTENER
4
Place the F Bottom Shelf (Thick) into position at the
bottom of the unit (the back has the hole in the center
of the long edge), line up all corner holes, and fasten
with G Sheet Metal Screws (two per corner).
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
F
Q
Q
Q
Q
Q
G
TWO SCREWS
PER CORNER
Install H Middle Shelves in desired locations, the
center hole in the long edge of each toward the back
(center hole in each group of five holes in back
panels will produce equally spaced shelves). Use a
sheet metal screw in each of four corners per shelf,
making sure the shelves are lined up with the proper
holes.
5
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
H
Set the unit upright and, from the back side, insert
a E Plastic Push Fastener into the BOTTOM
center hole of the back panel. Tap gently to set the
fastener. Now insert a fastener into the appropriate
center hole for each middle shelf, and tap into
place.
6
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
E
Q
Q
Q
Q
Q
Q
Q
Q
Q
Q
