Product Installation Guide
1.Turn off the vehicle engine.
2.Insert the SD card into the card slot.
ATTENTION Please use a high-speed SD card
(Class 10 or above), capacity is not less that
8GB. Max Capacity will be based on the model
you have purchased, please check the
specifications section of the manual. Please
format the card with the dash camera from the
settings section.
3.Fix the dash camera on to the windscreen of
your vehicle.
4.Connect the hardwire kit to the correct power
supply via the fuse tap.
Yellow Wire – B+ to the positive battery power
supply (constant power)
Red Wire – ACC (power supply when the ignition
is turned on)
Black Wire – GND to ground terminal in the
vehicle. This could be a bolt/screw that
is attached to the vehicles metal body.
AV cable – that is the video AV output from the
device so it can be connected to an AV
input device to show the camera’s
video footage.
