SAFE-T-COVER
1-800-245-6333
HCF600DS-
3
5. A. Using one (1) hexhead screw attach
Outside SS Corner Anchoring Brackets
to "A-B" sections. Using
one (1) anchor for each bracket fasten to concrete (FIG 1A). Fasten
Outside SS Corner Anchoring Brackets
at both corners on one side.
B.
Using one (1) hexhead screw for each bracket attach
Inside Alumiunm Anchoring Brackets
to "B"
panels on the inside bottom at concrete. Using one (1) anchor for each bracket fasten bracket to concrete
(FIG 1B). Fasten
Inside Aluminum Anchoring Brackets
to both “B” panels and concrete on one side.
C.
Insert
Inside Roof Clips
in “D1” (roof) panel at “B” panel. Using one (1) hexhead screw for each clip
attach to “B” panel. (Fig 1C).
D.
Using one (1) hexhead screw for each bracket attach
Inside
Aluminum
Anchoring Bracket to
“A”
panel on inside at bottom. Using one (1) anchor for each bracket attach bracket to concrete (Fig 1B).
6. Repeat Steps 5, 5A,5B, 5C and 5D on other side of enclosure.
7. Place “F” post in the center. Install
Inside Aluminum Anchoring Brackets
(Fig 1B) at bottom of “F” posts
and
Inside Roof Clips
(Fig 1C) at top of “F” posts.
8. Using hexhead screws install
Roof Cover Plate (Fig 1D)
at “D1-D2” roof seams.
9. Set "C" door panels and lock in place. (Solid "C" panel to be the
ACCESS DOOR PANEL
).
10. Provide ground-fault interrupter device in electrical circuit according to applicable codes. Install heater as
per manufacturer's instructions and governing local and national codes.
11. For maximum protection it is suggested that the area between the bottom of the enclosure and the concrete
base be caulked with the exception of the "C" panels.
DO NOT CAULK THE BOTTOM OF THE
"C" DOOR PANELS.
REMOVE MASKING FILM IMMEDIATELY
AFTER INSTALLATION
If these panels get wet when the film is still on, water will
irreversibly stain the panels.
Summertime heat will bake the
film on the panels.