4
UK
Roll the entire assembly up until
the Catch adheres to the cabinet,
keeping the stop tab in contact
with the worktop at all times.
Push the Catch firmly onto the
cabinet and hold for 30 seconds.
back plate
Keeping all 3 parts together,
swivel the EZ-Tool™/hook slight-
ly until the back plate is parallel
to the drawer/door as they come
into contact. Remove the protec-
tive layer to expose the adhesive
strip on the back plate.
30s
Gently close the drawer until it
comes in contact with the back
plate, and use your fingers to
press it firmly in to place for 30
seconds.
Still holding the back plate onto
the drawer/door, use your other
hand to push the slider forward
then down.
24h
Open the drawer and lift off the
EZ-Tool™. Leave for 24 hours
before first use.
To open and close
Open the drawer until it stops,
use your finger to push the slider
forward and down to release the
drawer/door. Closing slowly, the
catch will automatically reengage
as you shut the drawer. It will not
completely close until you push the
slider forward and down again.
To temporarily remove
Push the removal tab away from
the back plate and at the same
time slide the hook assembly to
the left. To reassemble, slide the
Arm back in until it clicks into
position.
To permanently remove
Use a blunt knife to carefully pri-
se the Catch and the back plate
from the surface, and rub away
any residual adhesive with your
fingers. Please keep the blunt
knife out of reach of children.
30s
push
tab
slide
