5
Slide the EZ-Tool™ (A) onto the Catch (B).
The broad plate at the end of the EZ-Tool™
fits into the recess on the adhesive side of
the Catch.
Place the EZ-Tool™ and Catch onto the Arm
(C) so that the locator pin fits into the hole on
the top of the Arm.
Remove the protective layer to expose the
adhesive strip on the Catch.
Open the drawer and hold the stop tab of the
EZ-Tool™ diagonally against the overhang of
the worktop.
stop tab
Roll the entire assembly up until the Catch
adheres to the cabinet, keeping the stop tab
in contact with the worktop at all times. Push
the Catch firmly onto the cabinet and hold for
30 seconds.
back plate
30s
Gently close the drawer until it comes in
contact with the back plate, and use your
fingers to press it firmly in to place for 30
seconds.
Still holding the back plate onto the drawer/
door, use your other hand to push the slider
forward then down.
Keeping all 3 parts together, swivel the
EZ-Tool™/hook slightly until the back plate
is parallel to the drawer/door as they come
into contact. Remove the protective layer to
expose the adhesive strip on the back plate.
24h
Open the drawer and lift off the EZ-Tool™.
Leave for 24 hours before first use.
To open and close
Open the drawer until it stops, use your finger
to push the slider forward and down to relea-
se the drawer/door. Closing slowly, the catch
will automatically reengage as you shut the
drawer. It will not completely close until you
push the slider forward and down again.
To temporarily remove
Push the removal tab away from the back
plate and at the same time slide the hook
assembly to the left. To reassemble, slide the
Arm back in until it clicks into position.
To permanently remove
Use a blunt knife to carefully prise the Catch
and the back plate from the surface, and rub
away any residual adhesive with your fingers.
Please keep the blunt knife out of reach of
children.
push
tab
slide
30s
UK - SC 802
