7
Step by step installation guide
Use a blunt knife to carefully prise the Lock
and Catch away from the surface, and rub
away any residual adhesive with your fingers.
Please keep the blunt knife out of reach of
children.
To permently remove
SAFE SecureHold™ adhesive is instantly
strong. It cannot be repositioned when
placed incorrectly so test each step first,
without exposing the adhesive. Before
installation, clean and dry the surface with a
50:50 solution of water plus white vinegar
or surgical spirit.
With the Lock fully assembled (as supplied),
peel back the protective layer to expose the
adhesive on the Lock (A).
Position the centre points of the strap
against the corner of the cabinet, and pull the
straps around the cupboard, keeping them
horizontal. Press the Lock firmly into position
for 30 seconds. Wherever possible, the Lock
should be positioned more than 70 cm from
the ground.
30s
Remove the protective layer to expose the
adhesive on the Catch (B).
Pull the Lock so that the straps are tight and
horizontal across the front of the cabinet.
Press the Catch firmly into position for 30
seconds to fix in place.
30s
Leave for 24 hours to ensure maximum
adhesion.
24h
To open and close
To release, squeeze the two buttons on
either side of the Hook together, and simul-
taneously roll it diagonally back towards the
corner of the cupboard.
The reverse action will re-engage the Lock.
UK - SC 803
