Safelift PushAround PA35, Original Instructions Manual

10

11

6.  HOW TO USE

6.1  Checks before using the lift

1.  Inspect the lift for any damage that may affect safety.

2.  Check that the batteries are charged (10). Battery charger 

light should be green. NOTE! The charging cord (14) must be 

connected to read the status.

3.  Disconnect plug (14) to use the lift.

4.  Check the function of the automatic wheel lock (11). It should 

not be possible to move the lift when the lift platform is raised.

5.  Check the function of the wheel brakes on the swivel wheels (4).

6.2  Main power switch (18)

The lift's main power switch must be activated when the lift is in use. 

Always switch off the main switch when not in use to save power.

6.3  Key lock (16)

The key lock must be in the "ON" position when the lift is in use and 

in the "OFF" position when the lift is locked.

6.4  Raising and lowering of platform (17)

Press the upper part of the control button to raise the platform. 

Press the lower part of the control button to lower the platform.

6.5  Battery charger switch (20)

The power switch must be in position "1" when charging batteries.

NOTE! When batteries are not being charged, the power switch 

must be in position "0", otherwise power is consumed.

6.6  Tilt indicator (21)

The lift is equipped with a tilt indicator (spirit level), so that the 

operator can check that the lift is only used on a level surface. When 

the bubble is located in the centre of the spirit level, the lift is safe to 

use. Maximum permitted inclination is 0°.

6.7  Emergency stop (15)

The lift is equipped with an emergency stop function. Press the 

All safety regulations, operating instructions, labels and national 

safety instructions / requirements must be carefully read, 

understood and complied with.