Safelift PushAround PA35, Original Instructions Manual

13

7.3  Battery charging

The lift’s batteries are located under the chassis control panel. The 

batteries are of AGM type, they are leak-proof and cannot be refilled 

with battery fluid. When batteries need to be replaced, this should 

only be done with batteries approved by the manufacturer.

The status of the battery charge can be seen on a lamp located next 

to the chassis pillar (10). The plug (14) must be connected to 230V 

to be able to read the status. The lift’s built-in charger optimally 

charges the batteries, so that overcharging cannot take place.

Battery acid is very corrosive. Always wear safety goggles 

when working with and near the batteries. Immediately rinse 

any spilled acid with clean water. Consult a physician in case of 

contact with battery acid.

WARNING!

Charge the batteries in a ventilated area. Do not charge the 

batteries near open fire or where there is a risk of sparks being 

generated.

Red light 

- Charging in progress

Green light

 - Charging complete

NOTE!

The charger must be connected to a socket with earth-fault 

protection. Do not use the lift while charging.

NOTE!

The switch on the chassis control panel must be in position "1" 

for charging to take place. When charging is not required, the 

switch should be in position "0".