Securing your Child in the Sit’n’Stroll™
& Adjusting the Harness System
On hot or sunny days, always check the fabric and
metal buckles before placing your child in the
restraint to avoid burns or discomfort.
Never use the Sit’n’Stroll
™
without the harness
securely buckled around your child and adjusted to
your child’s size.
Before using your new Sit’n’Stroll
T™
you must adjust
the harness system to fit your child. It is important
to adjust the harness system every time you place
your child in the Sit’n’Stroll
™
.
If your child is under one year of age and22 pounds
and his or her head is not yet to the top of the stitch
line, you should install the Sit’n’Stroll
™
rear-facing
in the vehicle. If your child is over one year of age
and at least 20 pounds, follow forward-facing
instructions. Between 20 and 22 pounds you may
use the Sit’n’Stroll
™
forward-facing
if your child is at
least one year of age.
Rear Facing
Crotch
Buckle
Latch Plates
Red
Button
7
Proper adjustment of the harness system for use rear-facing
1.
Open the buckle by pressing the red button and
pulling the latch plates from the buckle. Open
the chest clip.
2.
Place your child into the seat, making sure his
or her bottom is fully against the base of the
seat.
3.
The shoulder straps should be at or below your
child’s shoulders. Use the lower shoulder belt
slots. Use the shortest adjuster belt loop.
