After the code has been reset successfully, the User
must change the code before it can be used to open
the lock. Use a simple code such as 02-020202.
Manage the Manager
Master
In 701 locks supplied by Safelock Systems Ltd, a Manager
is installed with ID 01. To
delete
,
disable
,
enable
, or
reset
the Manager, the process is the same as for users but only
the Master code is valid to perform the command.
Add Manager
Generally, the Manager code can be reset rather than
being deleted. If the Manager code on ID 01 has been
deleted, it can be added again.
•
Enter #50
•
Enter the Master ID and code
•
Enter an available ID and new code
•
Press 4
to indicate ‘Manager’
•
Press 1 ind
icate ‘Open lock privilege’
•
Press Enter.
If accepted, the lock will signal 3 green
f short beeps
☼☼☼
Example to add a Manager:
Reassign ID 01
Master
In 701 locks supplied by Safelock Systems Ltd, a Manager
is installed with ID 01. ID 01 can be reassigned to be a
User profile so that the lock operates with a Master and 2
Users as shown in the hierarchy diagram below
•
Delete the Manager (ID 01)
•
When adding a user code into ID 01, follow the
process outlined for adding a user.
Example:
Engineer commands
Master
Additional commands are available to the Master, which
should only be used by engineers who are servicing the
lock. More information can for engineers can be found on
our website.
Key
Function
#22
Install a lock onto a keypad
#23
Uninstall a lock from a keypad
#25
Reset the lock to factory settings
#32
Install a new keypad onto an existing lock
(Command also available to Manager and Users)
#99
Initiate communication for a firmware update
Troubleshooting
Key press results in 2 red f short beeps
☼☼
The lock is in penalty caused by 4 consecutive incorrect
code entries. Wait for the 5-minutes penalty period to
elapse. After the penalty has elapsed, 2 further wrong
codes will again initiate a penalty. The trigger will reset
after a valid code has been entered.
3 red f short low beeps
☼☼☼
The code or command has not been entered correctly, re-
enter.
If a mistake is made during code or function entry
Press # to cancel
A key does not beep when pressed
If the LED still flashes, keypad beeps may have been
turned off. If there is no flash, the batteries may be
depleted. Change the batteries then set the date and time
to ensure accuracy of the audit data.
The safe or vault door does not open
If the lock system is otherwise operating normally, there
may be a mechanical fault with the safe. Contact a safe
engineer.
Document version
These instructions may be updated from time to time, visit
U
ode
ode
U
ode
U
ode
ode
U
ode
ode
U
ode
U
ode
ode
Master (00)
Users (01 + 02)