ASSEMBLY INSTRUCTIONS
1
Fix the 4 feet bases to the aluminum uprights using M8 sliding blocks with springs,
M8 x 16mm bolts and washers.
Position the legs as shown so that the
slots in the legs match up with the corner
brackets of the bed frame.
There are two left handed feet, with the
T-bolts at the front and the spring
washers/bolts to the right.
For the right handed feet, the T-bolts are
at the front and the spring washers/bolts
are on the right hand side of the
aluminum uprights.
2
Attach a leg to the frame. The frame will
sit directly on top of the leg foot.
Locate the T-bolts attached to the frame
into the leg slot ensuring that the sliding
nuts in the other slot line up with holes in
the frame. The distance between holes is
100mm and 20mm from each end, if you
mark with a pencil these measurements
the assembly process is easier.
3
Ensure that the T-bolt is located properly in the slot ie. with the groove in the end of
the T-bolt horizontal, add the two flange nuts and tighten.
4
Screw the two M8 bolts and washers into the two spring loaded sliding nuts and
fasten.
Assembly Instructions - Siesta
1
