step by step
www.spearheadbikes.co.uk
step 5
step 6
step 7
step 8
Position Back panel 5 into the groove on the base panel 1 , between the
side panels 2 and 3 , and under the Back Fascia panel 4 . Ensure the
holes along all four sides are aligned and screw together, tighten the screws
for the Back Fascia panel.
Position Front LH side panel 6 into the groove on the base panel 1 and
Rear LH side panel 2 . Ensure the holes are aligned and screw together down
the full length of the vertical joint and across the base.
Lift the Roof panel 9 onto the unit, covering the other panels and fascia pan-
els. Screw into place using the single screw holes. Fit the Roof security brackets
14 in the pair of slots on the top of each of the panels, each bracket is fitted
with a single screw.
5
6
8
9
14
Attach the Fascia panel 8 across the front of the unit as pictured. Screw
into both the Front side panels 6 and 7 .
SELF ASSEMBL
Y INSTRUCTIONS
X 18
15
X 18
15
X 4
15
X 44
15
9
14
