•
On the new screen, select
‘
Add New
’
and press the front button on the Quicklock.
1.
Select your Quicklock from the list.
2.
The password should be remembered from earlier set-up.
•
Once connected, select the drop-down menu titled
‘
Device Access
’
and then select RFID.
•
On the new screen select
‘
Add New Tag
’
at the bottom of the screen.
1.
A dialogue box will open saying
‘
Swipe Tag to Learn.
’
a.
If too much time passes, a new dialogue box will appear
‘
Warning, No Tag Learned.
’
b.
If you receive this message, select
‘
OK
’
and then repeat the
‘
Add New Tag
’
step.
2.
Place the new RFID accessory over the logo of the Quicklock.
a.
The Lynkd app will state that it is syncing the new tag and then syncing to the portal.
b.
A new screen will open, allowing the user to name the RFID accessory and view the Tag ID #
for the RFID accessory.
c.
Press Save at the bottom of the screen
▪
The Lynkd app will automatically save if the Quicklock turns off, or the RFID fails to
sync to the portal.
▪
The RFID will attempt to sync the next time the Quicklock is connected to the Lynkd
app.
Charging the Quicklock
•
The Quicklock has a rechargeable battery (700mAh LiPo).
1.
The battery can work for up to 2 years without charging.
•
If the Quicklock runs low on battery, (under 40%) it will flash blue and red when the front button is
pressed.
•
To charge the battery, remove the rubber plug from the back side of the Quicklock.
•
Plug in the Micro USB cable that came with the Quicklock.
1.
A 5v 2A charger is recommended for charging the Quicklock (*not included).
2.
The Quicklock will begin to flash red, indicating that it is charging.
•
A full charge will be reached within 2 hours.
•
*NOTE* replace the rubber plug after charging to prevent dust/moisture from entering the Quicklock.
