Original Fireguard
Model:
ST-SOF
Safetots Limited, Units7,9,10 The Orbital Centre, Gunnels Wood Road, Stevenage, SG1 2NB, UK
+44 1438 728888
info@safetots.co.uk
I.5 sof 04.22
ASSEMBLY INSTRUCTIONS
1 Remove Cable Ties
2 Unfold Left Hand Assembly
(This side has the warning tag attached).
Press Clips (A) on top panel to side panel to secure. (Fig 1)
3 Repeat for Right Hand Assembly
4 Lay the Left Hand Assembly over the Right Hand Assembly.
Adjust to give the desired overall width by increasing or
decreasing the overlap. (Minimum overlap of 8cm)
5 Secure the Two Assemblies
Ensure the grids on each panel line up. Use the 4 Fixing Plates
(Fig2) in the positions shown at Point B with the smaller plates
underneath.
If you are using the minimum overlap
use only 2 Fixing Plates (Fig 3)
FIXING INSTRUCTIONS
Prepare the surface as appropriate and fit the Screw Eyes
firmly into the mounting surface at the height of the
Securing Clips.
Attach the Securing Clips on both sides of the Fireguard
to the Screw Eyes.