20
OPERATION
CAUTION:
If at any point during the charging process none of the LEDs are lit, remove the battery
pack from the charger to avoid damaging the product. DO NOT insert another battery. Return the
charger and battery to your nearest service center for service or replacement.
CAUTION:
Charge in a well-ventilated area. Do not block charger vents. Keep them clear to allow
proper ventilation.
BATTERY PROTECTION FEATURES
37V/10,5 Ah lithium-ion batteries are designed with features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these built-in features may cause the battery and the tool it
is powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the trigger and resume normal operation.
NOTE:
To prevent further shut down of the battery, avoid forcing the tool.
If releasing the trigger does not reset the battery and tool, the battery pack is depleted. If depleted, the
battery pack will begin charging when placed on the lithium-ion charger.
TO CHARGE
A fully discharged battery pack with a temperature between 0° (32°F) and 65° (150°F) will charge in about an
hour.
•
Use battery pack only with the recommended Safetrack charger.
•
Connect the charger to a power supply.
Make sure the power supply is normal household voltage,
240 volts, AC only, 50/60 Hz
.
•
Attach the battery pack to the charger by aligning the raised ribs on the battery pack with the grooves
in the charger, then slide the battery pack onto the charger.
See Figure 1.
•
Do not place the charger and battery pack in an area of extreme heat or cold. They will work best at
normal room temperature.
Note:
The charger and battery pack should be placed in a location where the temperature is more than
10
° (
50°F) but less than 38
° (
100°F).
•
The battery pack will become slightly warm to the touch while charging. This is normal and does not
indicate a problem.
•
After charging is complete, the green LED will remain on until the battery pack is removed from the
charger or charger is disconnected from the power supply.
When batteries become fully charged, unplug the charger from the power supply and remove the battery
pack.
