22
BATTERY CHARGER
CHARGING THE BATTERY
On the battery charger there are two lights (RED and GREEN)
When the RED light flashes the battery is charged (2% - 80%). When the GREEN light flashes the last 20% of
the battery is charged.
When the green light stops flashing and remains lit green, the battery is fully charged and ready for use.
CAUTION
: When both the RED and GREEN light are simultaneously lit than either the battery charger or the
battery its self is too hot. If the RED and GREEN light on the charger are alternately flashing RED/GREEN,
there is a general error.
BATTERY CHARGING TEMPERATURE PROTECTION
If the battery reaches 50
℃
, the charger will stop charging. Error signals: the RED and GREEN light are
simultaneously lit RED and GREEN. The charger will start charging again if the temperature of the battery is
45
℃
or less (Over temperature recovery).
SIGNALS ON THE MACHINE
Signals well-functioning drilling machine
•
When the ST.33 drilling machine is well positioned on the work piece, press the main power (white)
switch to on the machine. The LED will flash 2x GREEN and then remain lit GREEN.
•
When the motor is switched on (green switch), the main power switch will be lit yellow.
Signaling malfunctioning of the drilling machine
•
When the (white) main power is flashing RED, the battery is low;
•
When the (white) main power is flashing YELLOW, there is over current and the motor will stop.
Supply of Signalling/Electrification/Track/Safety material
Mollebergavägen 339-24, 245 93 Staffanstorp, Sweden
Direct Tel. +46 40 44 53 00
Tel.
+46 (0)40 44 53 00
