With the Admin Installer tab open from the App,
bring the phone in range of the SABRE Module and
once visible from the App, highlight and select
“Configure”.
Select the corresponding IDENTITY SYSTEM
from the drop down box. Assign a short
“Name”
and
“Description” using alphanumeric characters.
Enable the slider for “Self Enrollment” if you
intend to allow your users to enroll mobile
credential using their existing legacy cards from
this reader. Click
‘Save’ to successfully complete
reader configuration.
When the SABRE Module information is
successfully saved to the Credential Manager,
and assigned to the Identity System, the new
description will appear in the Admin Installer with
a unique serial number assigned.
FCC
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF Exposure: Mobile RF exposure device, there shall be a minimum separation of 20 cm between the device
and any users or installers.
FCC PART 15.19 STATEMENT: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Canada Radio Certification
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
To open the door, simply present your mobile device
running the Safetrust Wallet application to the
SABRE Module. When the phone is within the
configured activation range, the LED within the
assigned credential for this identity system will be
green in color. If
“Auto Authenticate” is enabled for
the mobile credential, the credential will be sent to
the SABRE Module whenever the mobile device is
The two main configuration options for this are the
“Sensitivity Level to Activate” slider, which
determines how easily your mobile device with
pick
up the activation zone, and the “Anti Passback”
setting, which defines the
within the activation zone.
Quick Start Guide
SABRE Module
www.Safetrust.com
sales@Safetrust.com
+1 510 9 SAFE 09
SAFETRUST MODEL SA210
FCC ID: 2ANI5
SA
210
IC ID: 23133
-
SA210
MADE IN THE USA
