C.
Basic U
se
25
Thread harness over the metal bar, between
bar and plastic handle of the harness/headrest
adjuster in back.
Harness system must be reattached correctly.
Buckle’s metal retainer must be completely
through pad and shell.
Failure to follow these warnings can result in
serious injury or death.
Thread Harness
Between Metal Bar
and Plastic Handle
Thread harness
OVER
the
metal bar,
BETWEEN
metal bar and plastic
handle of the
harness/headrest adjuster.
7.
Attach Harness Straps
to Splitter Plate
Fit loops on harness ends
completely on
the splitter
plate.
8.
4
5
6
Thread harness straps
through each buckle
tongue
(4)
. Thread the
chest clip
(5)
. Do the same
to the other harness end.
Do Not twist harness.
Push harness ends through
slots in headrest
(6)
.
6.
Thread Harness Guides
on Harness Strap
Slide one harness guide on
each harness strap end.
4.
Secure Harness Guides
Press harness guides into
the holes in the pad and
shell.
5.
Check Buckle
Pull up on buckle to make
sure it is secured.
The
buckle must not pull out.
2.
3.
Thread Harness Strap
NOTE:
For easier assembly,
remove the harness guides.
See section C-7, step 4.
Thread the harness down
through slot on left side of
plastic shell
(1)
and up
through slot on right side
(2)
.
NOTE:
Make sure sewn end
of the harness strap loop
faces the buckle before
starting.
Take both ends of the
harness and make them
even in length.
NOTE:
Make sure harness
tightening strap is between
the harness strap and shell
as shown.
1
2
26
4358-4837 Elite SF1 EOU 7/10/09 2:47 PM Page 27
