21
Care and maintenance
CLEANING COVERS AND HEADREST
HEADREST COVER: Adjust the booster seat headrest to its highest position.
Separate velcro at the back of the headrest and remove cover. Ensure Air Protect
Cells (x2) are removed. Do not wash with Air Protect cells still inside.
MAIN BODY COVER: Separate velcro at the back of the seat.
Pull around the armrest and remove cover off the seat.
•
The seat covers can be machine washed in lukewarm water on the ‘delicate’ cycle.
•
Tumble dry for 10 - 15 minutes on low heat.
•
DO NOT BLEACH
•
DO NOT DRY CLEAN
•
DO NOT IRON
•
Once they are fully dry, they should be refitted in the following sequence.
FITTING THE MAIN BODY COVER
Starting at the armrest, place the trim on the back and base and fasten the velcro
at the back.
FITTING THE HEADREST COVER
Re-insert Air Protect cells (x2) into headrest cover.
Extend the booster seat headrest to its highest
position then fit the headrest cover (pull on cover)
by stretching it over the headrest.
* Style and design may vary for the trim.
STRAP