Moving UAS/Vehicle Belt Loops
and UAS Belts
14
4.
Pull Pad Off Bottom of
Shell
Pull buckle through pad.
Remove pad.
Cleaning Pad
Machine wash separately with cold water on a gentle cycle. Do
not use bleach. Tumble dry separately for 10-12 minutes on low
heat. Remove immediately.
Cleaning Harness Straps, UAS Belts, UAS/Vehicle Belt
Loops
Spot clean using warm sudsy water and damp cloth.
Replace Pad
Place foam inserts in shell if they have been removed. Starting
from bottom of car bed, slip pad on shell. Pull buckle through
pad. Pull buckle tongues through pad and wrap pad around top
of shell. Make sure harness and buckle straps are not twisted.
Reattach elastic to plastic buttons on sides of shell.
WARNINGS:
Do not use the car bed without the
seat pad or foam inserts.
Failure to do this can result in serious injury or death.
1.
Pull Corners of Pad
Off Shell
2.
Lift Metal Clips Up
and Pull Belt Loops
Out of Slots in Shell
13
If needed, the UAS/Vehicle belt loops can be moved to either
side of the car bed.
Both belt loops must be on the same side as vehicle seat back.
The UAS belt and UAS/Vehicle belt loops
CANNOT
be threaded
into the same slots in the shell. When you move the belt loops,
you
MUST
also move the UAS belts.
continued on next page