C-2
Installing Harness System
Position Harness System
Orient harness system into
position.
Make sure buckle is
facing up toward you.
Insert the buckle’s metal retainer
through the desired location.
From the bottom, pull buckle’s
metal retainer
completely
through pad and plastic base.
Lock the metal retainer in place.
1.
Check Buckle
Pull up on buckle to make sure it
is secured.
The buckle must not
pull out.
2.
Install both Rear Metal
Harness Retainers
From the top of the seat base,
fold up the seat pad to expose
the two rear harness slots.
With one hand, push one
retainer down each slot while
pulling the retainer through
from the bottom of the seat.
3.
Thread Vehicle Belt
Attachment Loops into
Seat Base
From the top of the seat base,
thread one vehicle belt
attachment loop into each rear
harness slot as shown.
From the bottom of the seat,
thread each vehicle belt
attachment loop into the rear
metal harness retainer.
4.
H
A
R
N
E
S
S
A
R
N
L
A
T
C
Harness System MUST NOT
BE TWISTED
Straighten out the harness
system to make sure the
harness straps are not twisted.
5.
14
13
continued on next page.
C.
Basic U
se
4358-4856 Go Booster 8/31/09 12:02 PM Page 15