continued on next page
23
24
Put Car Seat into
Position 1 & Place
Car Seat
Forward-
Facing
in Back Seat
The vehicle seat back
MUST
be upright.
1
Locate Vehicle Top
Tether Anchors
Review your vehicle
owner’s manual for top
tether anchor locations
and how to route the
tether strap when there
are vehicle headrests.
2
4
Loosely Attach
Tether Hook to
Vehicle’s Top
Tether Anchor
Only
use semi-
reclined
Position
2 if necessary
to
install the car seat
fl ush against the
vehicle seat back.
If your vehicle has
a headrest that
interferes with a
fl ush car seat fi t,
check your vehicle
owner’s manual
to see if it can be
removed, adjusted,
or if there are other
possible seating
locations for you to
install.
Recline handle is at
front of car seat.
3
Lift Tether
Adjuster to
Loosen Tether
Strap
5
OR
Locate
Forward-Facing Belt Path
& Route
Vehicle Belt or Lower Anchor Belt Through It
For the LATCH belt:
You may need to fully lengthen the belt
before routing it into the belt path. Squeeze the adjuster button
and pull the belt out as shown.
Thread the connector with the adjuster closest to it through the
Forward-Facing Belt Path
opening as shown.
Vehicle Belt or Lower
Anchor Belt Goes:
• under the car seat pad;
AND
• across the car seat;
AND
• out the other
Forward-
Facing Belt Path
opening.
DO NOT twist the belt.
6