23
Rethread harness straps
into new upper harness
slot location.
NOTE:
DO NOT twist the
harness straps.
b.
PUSH
From the back of the
infant restraint, fit the
harness strap loops onto
the splitter plate.
NOTE:
Make sure sewn
end of the harness
strap loops faces towards you. DO NOT twist harness
straps or harness adjustment strap and make sure the
harness straps are COMPLETELY ON the splitter plate.
c.
Do not use this infant restraint if
the top of your infant’s head is
within 2.5 cm (1 in.) from the top of
the infant restraint.
Make sure the harness strap height is correct
for your infant’s size. Verify frequently.
Failure to reinstall harness straps correctly
could result in serious injury or death.
Incorrect use of the harness system is the
most common mistake people make. It is very
important to read, understand and follow all
instructions and warnings.
Failure to follow these steps can result in
serious injury or death.
2.5 cm
1 in.
C. Basic Use
24
C-7
Securing Infant in Infant Restraint
Position Harness
Straps Over the
Infant’s Shoulders
Place the infant’s bottom
and back flat against the
infant restraint.
This will increase
comfort and allow the
harness straps to be
properly tightened.
1.
Buckle Harness
Straps
Push each buckle
tongue into buckle until
you hear a “click.”
Remember to always
pull up on harness
straps to make sure
buckle is locked.
2.
Close Chest Clip
Insert right half of chest
clip into left half and
snap together.
3.
4358-6693 Light N Comfy Elite, OnBoard 22 ENG.indd 25-26
4358-6693 Light N Comfy Elite, OnBoard 22 ENG.indd 25-26
11/5/14 10:47 AM
11/5/14 10:47 AM
