only (120V AC outlet)! To prevent entanglement and overheating,
DO NOT
use
extension cords.
• The AC adapters may become slightly warm to the touch during operation. This is
normal.
• Position the AC adapter cords so that they are not walked on or pinched by items
placed upon or against them, paying particular attention to cords at AC adapter plugs,
wall plugs, and the point at which the cords attach to the Transmitter and Receiver.
• This product should be serviced only by qualified service personnel at Dorel
Juvenile Group when:
- An AC adapter or its plug is damaged,
- The Transmitter or Receiver have fallen,
- Liquid has spilled into the Transmitter or Receiver or
- The Transmitter or Receiver do not appear to operate normally or exhibit a marked
change in performance
•
DO NOT
attempt to service this product beyond that described in the
Troubleshooting section at the end of these instructions.
All other servicing should be referred to qualified personnel at Dorel Juvenile Group.
NOTE:
The LEDs emit IR (infra red) light that is not harmful.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT
EXPOSE THIS PRODUCT TO WATER OR MOISTURE. DO NOT REMOVE
COVER ON BACK OF TRANSMITTER OR RECEIVER. NEVER ATTEMPT
TO OPEN THE CASE OF THE PRODUCT. THIS IS DANGEROUS AND WILL
VOID THE WARRANTY. NO SERVICEABLE PARTS INSIDE. REFER
SERVICING TO DOREL JUVENILE GROUP CONSUMER RELATIONS
(800-544-1108).
CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE
PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions
for satisfying RF exposure compliance. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
