D. Closing up the Device
!
7
STEP 7:
Once everything is slid back in, try the best
you can to tuck any excess wires back in the
device. Replace the end piece. From this
point on, follow the Steps in Section D
“Close up the device”.
STEP 1:
Now that you have either done a hard reset
or replaced the battery, you now want to
properly seal up and close the device. The
most important part here is to make sure the
watertight seal/gasket is lined up. Insert the
screws, line up with the holes and seal up
the device.
STEP 2:
Once you have the screws in and snugged
up. Your device should appear like the one to
the left. You should see a very small gap if
any at all to ensure a proper watertight seal.
YOU’RE DONE!
Safety Track - 249 Main St. Belleville MI 48111 - 734-699-7633
