Sensor Settings
The Sensor Settings page
confi gures settings for the sensors
and fault statuses.
Sensor Inputs
For each sensor input, enter an
alphanumerical name in the
Name
fi eld and the number of volts
(between 1 and 30) that cause the
sensor to become active in the
Threshold
fi eld. In the
Action
fi eld,
select type of event each sensor
triggers: Metadata, Backup Power
Event, Simple Event, Event While
Active, or Start/Stop Event.
Enable J1939
Select this option to enable J1939
communication with compatible
devices.
Relay Outputs
For
Relay Out 1
and
Relay Out 2
,
select between None, External
Device, and Fault Status. External
Device powers an external relay.
Select Fault Status to display
additional Fault Status Priority and
Fault Status fi elds.
Fault Status Priority
Select 1, 2, or 3 in the
On
,
Slow Pulse Rate
, and
Fast Pulse
Rate
fi elds to prioritize the fault statuses below assigned
those respective signals.
Fault Status
For each fault status, select On, Slow Pulse Rate, or Fast Pulse
Rate signal. These signals power an optionally installed
status LED.
• Internal SSD Failure
• Internal SSD Full
• Camera Failure
• GEO Radius Violation
• Vehicle High Speed
• Vehicle High Acceleration
• Temperature
• GPS Failure
• Removable Drive Failure
• Removable Drive 90% Full
• Battery Failure
• Offl oad Failure
• SD Card Failure
Click Save Changes to save changed entries.
24
ROADRECORDER 8000 NVR USER GUIDE
