REAR VIEW SAFETY
24
Troubleshooting
Monitor Display Blue Screen & Displays No Signal
•
Do a hard reset, unplug all
cables and power cables from
multiplexer (silver box) leave
out for 1 minute and then
re-connect them.
•
Check to ensure that the con-
nection to the camera is tight.
•
Verify camera cable is plugged
into port labeled
Backup Camera
•
Verify that the blue positive
trigger on power harness is
put to power 12v+.
If the problem still persists,
verify that alternate ports
work. If alternate ports do not
work, remove Blue Trigger wire
from 12V+ and select alter-
nate channels.
Monitor Will Not Power-Up
(no backlight on power button)
•
Check fuse
•
Check 12v+ to monitor
•
Check ground connection
No Image On Screen
•
Verify camera is on correct
camera input
•
Verify cable is connected to
monitor
•
Verify camera is connected to
cable
•
Connect known working
camera and cable to monitor.
•
Verify Blue trigger is receiving
power
Audio on Camera
•
Verify chosen camera has audio
•
Verify volume setting
•
Confirm that the Blue audio
trigger is connected to 12v+
Summary of Contents for RVS-770616N
