www.safetyxpress.com.au
PRODUCT INFORMATION &
INSTALLATION GUIDE
1300 049 246
Specifications
SKU
BOLSM90X
Material
Hot Dip Galvanised Steel
Colour
Powder Coated Yellow with Class
1 Red Reflective Tape
Black Plastic Cap on top
Dimensions:
Height:
900mm
Diameter:
90mm (Pole) 225mm (Base)
Wall Thickness:
3mm
Base:
4 Mounting Holes
16mm each in Diameter
Item Weight
7.5kg
Fixings
4 x FREE Mounting Bolts Included
per bollard
(standard fixings kit)
Surface Mount Bollard
Installation:
1. Read instruction steps from beginning to end.
2. Determine exactly where the bollard will be
placed. If you are installing more than one bollard,
it is a good idea to mark the ground to ensure
that you have a straight line to assist you with the
correct placement of your bollards.
3. Using your hammer drill, drill a guide hole in the
surface, through each hole in the bollard using the
drill bit. (This is to mark the surface so that you
know where to continue to drill).
Tools Required:
•
Hammer drill with 14mm drill bit for M10 coach screw
100mm, or 10mm drill bit for M10 concrete screw
anchors
•
Fixing kit (M10 coach screws 100mm, or 60mm M10
concrete screw anchors, or 100mm M10 concrete
screw anchors)
•
The correct sized socket
• A hammer
•
A hand broom or industrial vacuum
4.Remove the bollard and brush or vacuum away the
dust.
5. Continue to drill each guide hole to almost the entire
length of your fixings.
6. If you are using a plastic plug component, put it in the
drilled hole and hammer in.
7. Place the bollard over the holes, line up and place
your fixing in the holes and screw or hammer in.
8. Use your socket to tighten the screw if applicable. Be
careful not to overtighten.
2
2
MONTHS
MONTHS
FREE
Fixings
Reflective
