www.safetyxpress.com.au
PRODUCT INFORMATION &
INSTALLATION GUIDE
1300 049 246
Page 2 of 4
Installation:
1. Read instruction steps from beginning to
end.
2. Determine exactly where the bollard will
be placed. If you are installing more than
one base plate, it is a good idea to mark the
ground to ensure that you have a straight line
to assist you with the correct placement of
your bollards.
3. Using your hammer drill, drill a guide hole in
the surface, through each hole in the bollard
using the drill bit. (This is to mark the surface
so that you know where to continue to drill).
4.Remove the bollard base plate and brush
or vacuum away the dust.
5. Continue to drill each guide hole to almost
the entire length of your fixings.
6. If you are using a plastic plug component,
put it in the drilled hole and hammer in.
7. Place the base plate over the holes, line up
and place your fixing in the holes and screw
or hammer in.
8. Use your socket to tighten the screw if
applicable. Be careful not to over tighten.
Tools Required:
• Hammer drill with correct sized drill bit
• Fixing kit
•
The correct sized socket
• A hammer
• A hand broom or industrial vacuum
Base Plate
Installation
Note: Refer to
next page on
how to remove
bollard from
base plate
