Introduction To The Components
16
Simple Stationary Pointer
The simple stationary pointer is colored white and
is located on the left side of the machine on the
red safety bar. This is directly above the
machine’s table. See Fig. 26. This pointer is used
for quick setting of the table height according to
your material thickness. To use this gauge, place
your material down on the table and underneath
the white tab. Adjust the table up or down until
the highest point on your panel fits underneath the
white stationary pointer. This will prepare you to
sand without worrying about overloading the
machine. This gauge is designed to make a quick,
simple table height adjustment.
Optional Digital Positioning
Gauge System
The optional digital read out system utilizes a
digital display to help you appropriately adjust the
table height. See Fig. 27. This gauge measures the
distance that you are raising or lowering the table,
in relationship to the contact roller. You will also
use it for measuring the actual dimension on your
last (finishing) sanding passes. Refer to the
operating and installation instructions included
with the digital read out for more information on
operating this gauge.
Stationary Pointer
Figure 26: Stationary Pointer
Figure 27: Optional Digital Read Out
