Safeway PHV-130, Instruction Manual

OPERATING INSTRUCTIONS 

1. CLAMPING WITH HYDRAULIC POWER

a. Insure that the four lines on the

hydraulic spindle  34  are visible. To

bring them into full view hold the
cylinder 35  body and turn the

spindle  32  counter clockwise.

b. Slide the collar   33   to the non

en-gauge position.

c. Turn the handle clockwise  to

bring the movable jaw into the
work piece

d. The vice will lock up as a

mechanical vice. When the

handle starts to tighten bump the
handle sharply clock wise with

your hand and the hydraulic

mechanism will commence. The
spindle   34   will remain

stationary and the outer handle

will turn.   

e. The lines engraved on spindle  34
can be used as a guide to indicate the 

amount of pressure applied to the job. 
Maximum pressure is obtained when all the 

lines have been covered. 

f. To undo the vice wind the handle anti clock

wise. The outer spindle   32  will rotate with   
34  remaining stationary until the hydraulic 

system has reached its home position the 
spindle   34  will rotate to undo the 

mechanical side of the system. 

Page 5

Instruction Manual for PHV-130 (V330)

05/12/2014