IMPORTANT:
Read these instructions carefully so as to familiarize yourself
with the appliance before connecting it to its gas container. Keep these
instructions for future reference. Provide ample ventilation in the area where
the appliance is used. These gas appliances consume oxygen when in use.
Only use in a well ventilated area for the efficient performance of the appliances
and the safety of the occupants of the area in which they are used.
Important information for the user
If installed in a fixed position with a piped gas supply from a remote
source e.g. with the gas cylinder outside the building, this appliance
May only be installed by a registered LP Gas installer.
All registered
installers are issued with a card carrying their registration number. Ask to be
shown the card before allowing the installation work to commence and make a
note of the Installer Registration Number. Upon completion of the Installation,
the installer is required to explain the operational details of the appliance
together with the safety instructions. You will be asked to sign acceptance of
the installation and be provided with a completion certificate. You should only
sign for acceptance of the installation when the Installation is completed to your
satisfaction.
If the appliance is placed directly on a suitable worktop in a freestanding
manner with the gas hose and regulator assembly connected to the cylinder
standing on the floor adjacent to the work top, then the appliance does not need
to be installed by a registered LP Gas installer. Note that there are limitations
regarding the sizes of cylinders that may be used or stored inside buildings. For
a flat the max allowed is 9 kg. For a house the max allowed is 19 kg.
It is also important to note that where used as indicated above, the gas cylinder
may not be closer than 300 mm to a stove or any other source of heat.
Important information for the installer.
If installed in a fixed position with a piped gas supply from a remote
source e.g. with the gas cylinder outside the building,
this appliance may
only be installed by a LP gas installer registered by SAQCC-Gas.
The installation must be carried out according to the requirements of SANS
10087-1 and any fire department regulations and/or local bylaws applicable to
the area. If in doubt check with the relevant authority before undertaking the
Installation. Upon completion of the installation you are required to fully explain
and demonstrate to the user the operational details and safety practices
applicable to the appliance and the installation. The appliance has been
designed specifically for use with LPG. Read the instructions carefully before
commencing the installation.
7. Storage
· If the appliance is not to be used for lengthy period disconnect it from the
cylinder and store in a clean dry place.
8. Spares and Accessories
· Always use genuine spares as they have been designed to give optimum
performance. For details to of where to obtain the spares refer to your local
gas appliance dealer and advise them of the model number of your appliance.
Cooking Grid
