Terminal Block Group
Sailer Manual HPVFE
44
t201 [Digital In1 Sel]
Related Parameter(s):
d012, d014, P108, P109, P110,
(I/O Terminal 5)
t211-t214, A401, A402, A404, A405, A410-A413
t202 [Digital In2 Sel]
Stop drive before changing this parameter.
(I/O Terminal 6)
Selects the function for the digital inputs. Refer to the flowchart on
page 1-19
for more information on speed reference control priority.
Options
0
“Not Used”
Terminal has no function but can be read over network communications via
d014
[Dig In Status]
1
“Acc 2 & Dec 2”
When active,
A401
[Accel Time 2] and
A402
[Decel Time 2] are used for all ramp
rates except Jog.
Can only be tied to one input.
Refer to the flowchart on
page 1-20
for more information on Accel/Decel selection.
2
“Jog”
When input is present, drive accelerates according to the value set in
A405
[Jog
Accel/Decel] and ramps to the value set in
A404
[Jog Frequency].
When input is removed, drive ramps to a stop according to the value set in
A405
[Jog Accel/Decel].
A valid “Start” command will override this input.
3
“Aux Fault”
When enabled, an F2
Auxiliary Input
fault will occur when the input is removed.
4
“Preset Freq” (Default)
Refer to
A410 - A413
[Preset Freq x].
Important:
Digital Inputs have priority for frequency control when programmed
as a Preset Speed and are active. Refer to the flowchart on
1-19
for more
information on speed reference control priority.
5
“Local”
When active, sets integral keypad as start source and potentiometer on the integral
keypad as speed source.
6
“Comm Port”
When active, sets communications device as default start/speed command
source.
Can only be tied to one input.
7
“Clear Fault”
When active, clears an active fault.
8
“RampStop,CF”
Causes drive to immediately ramp to a stop regardless of how
P107
[Stop Mode] is
set.
9
“CoastStop,CF”
Causes drive to immediately coast to a stop regardless of how
P107
[Stop Mode]
is set.
10
“DCInjStop,CF”
Causes drive to immediately begin a DC Injection stop regardless of how
P107
[Stop Mode] is set.
11
“Jog Forward”
Drive accelerates to
A404
[Jog Frequency] according to
A405
[Jog Accel/Decel]
and ramps to stop when input becomes inactive. A valid start will override this
command.
12
“Jog Reverse”
Drive accelerates to
A404
[Jog Frequency] according to
A405
[Jog Accel/Decel]
and ramps to stop when input becomes inactive. A valid start will override this
command.
