Ver. 1.0
You could enter into the programing mode to re-set the function code. To use and program the hotel
safe, please kindly read and follow the instructions carefully:
Important Tips
:
The digital in every position indicate the different function.If you wouldn’t like to change the current
setup,you only need to input the same digital in corresponding position or press
“
#
”
to enter
into the next screen till quit .
Once you changed their setup ,please press the key
“
#
”
to save the latest setup when quit the
rogramming mode and as long as you enter into the next screen,any changes on previous screen
will be saved automatically.(because you also can enter into the next screen by inputing digitals)
Door position:
OPEN (initial code is
1234
initial master code is
000000
)
key in
“
＊＊
”
,the hotel safe LED will show
“
PROG
”,
then input the programming code
“
7510
”
in 5
seconds after “
PROG
” disappeared. Now the operation screen starts to enter into programming mode
(input
key “
#
” again,you will enter into the next screen)
Program Mode
First Screen
The Options
:
(1) CODE APPEARANCE ON THE SCREEN
Press 0
– The presonal code number will not appear on the screen each time when you input the code
(namely is the screen just shows “
--------
” instead of digit code when you input the code to
open or the door ).
Default Parameter
Press 1
-The personal code number will appeared each time.
HOTKEY FUNCTION:
When the parameter you choosed is “
0
”, please press
“
9#
”
, then input the code ,you will find the screen will
display digit code inputing.
When the parameter you choosed is “
1
”, please press
“
0#
”
,the screen will display
“
HIDE
“
,then input the
code ,you will find the display just show “
------
” instead of digit code.
Please note
“
HOTKEY function
“
only take effects to the current operation,that means activate
“Hide or
display the digital” by HOTKEY is temporary.
SAGA
