Sage Kitchen Wizz Pro BFP800, Quick Manual

8

9

EN

ASSEMBLY

BEFORE FIRST USE

Before using your Sage

®

 food processor, 

become familiar with all the parts. Remove all 

packaging materials and promotional labels, 

being careful when handling the processing 

blades and discs as they are very sharp. Wash 

the processing bowl, processing lid and other 

attachments in warm, soapy water. Rinse and 

dry thoroughly. (Refer to cleaning, care and 

storage section).
1.  Place the motor base on a dry, level work 

surface. Place the processing bowl on 

to the motor base with the handle in line 

with the ALIGN HANDLE graphic on  

the motor base.

2.  Turn the processing bowl clockwise  

until the handle aligns with the  

TURN TO LOCK graphic.  

The processing bowl should  

be securely locked into position.

3.  If using a disc, first assemble the disc 

spindle onto the bowl drive coupling. 

Orientate the disc so that the side you 

wish to use is facing upwards. Hold 

the disc by the centre plastic moulding 

and position the central hole above the 

attachment spindle. Push down firmly 

until fitted correctly.  

(Please note that these discs only fit the 

larger processing bowl). 

4.  For using the processing blades, carefully 

grasp either the 4 blade processor, dough 

blade or mini processing blade using 

the central plastic support and position 

it over the bowl drive coupling and push 

down until inserted correctly. If using the 

mini processing blade, ensure the mini 

processing bowl is assembled into the 

main bowl first.

ASSEMBLY

5.  Place the processing lid onto the 

processing bowl so the feed chute is 

slightly right of the bowl handle and the 

arrow graphics are aligned 

 .  

Holding the feed chute and pressing 

down firmly at the same time, turn the lid 

clockwise (as indicated by the graphic) 

so the ‘Locking Tab’ on the lid slots into 

the ‘Interlocking Safety Catch’ on the 

handle. The lid should be securely locked 

into position.

NOTE

The food processor will not operate 

unless both the processing bowl and 

lid are correctly locked into position.

CAUTION

The processing blade (including 

the mini bowl blade) and discs are 

extremely sharp, handle with care 

at all times.

6.  Insert the power plug into a 220–240 volt 

power outlet and switch the power  

outlet on.

7.  At the end of processing, always wait until 

the blades or discs have stopped spinning 

before unlocking and removing the lid. 

To remove the processing lid, ensure the 

POWER / OFF button has been pressed, 

the power is switched off at the power 

outlet and the cord is unplugged from the 

power outlet. Holding the feed chute and 

pressing down firmly at the same time, 

turn the lid anti-clockwise so that the 

arrow graphics are no longer aligned.

8.  Remove the processing bowl (before 

removing blade or discs) by turning it  

anti-clockwise until the handle is in line 

with the ALIGN HANDLE. Lift the bowl  

off the motor shaft. When removing the 

discs – carefully remove by gripping the 

plastic hub on the centre of the disc and 

lifting the disc up and away from the pin 

on the spindle.

OVERLOAD PROTECTION SYSTEM

If the motor overloads, the food processor will go 

to STANDBY mode and OVERLOAD icon in the 

LCD starts to flash. The food processor can still 

be switched off by pressing the POWER / OFF 

button. To operate the food processor again, 

allow the machine to cool for approx 30 minutes.
Some stiff mixtures, such as dough, may cause 

the dough blade to rotate more slowly than 

normal. If this happens, do not process for 

longer than 1 minute.