7
OPERATING YOUR SAGE
®
MILK CAFÉ
™
FROTHING HOT MILK
1. Place the milk frother on a flat level surface
and plug the power cord into a 220–240V
power outlet. The START | STOP button
surround will illuminate.
2. Select the ‘Capp’ or ‘Latté’ frothing disc.
Choose the ‘Capp’ disc for thick and
creamy froth or the ‘Latté’ disc for smooth
and silky milk.
3. Insert the frothing disc onto the shaft at
the base of the milk jug. Ensure the disc
is inserted the correct way with the
wider part of the disc at the bottom
of the jug. The disc should ‘click’ securely
onto the shaft.
NOTE
If the disc is not inserted correctly it may
dislodge during operation, a grinding noise
may be heard, or milk will not swirl.
WARNING
Frothing disc is a choking
hazard. Children must always
be supervised and never left
unattended with the appliance.
4. Pour the required amount of cold, fresh (or
freshly opened) milk into the milk jug then
cover with the jug lid.
NOTE
Never operate without the minimum level
of liquid in the milk jug. The milk frother
will automatically turn off if the milk jug is
empty. If this occurs, you will need to wait
for the milk frother to cool down before re-
use, refer to page 8.
5. Ensure the jug lid is securely attached. Place
the milk jug onto the power base.
6. Turn the START / STOP push-dial to the
desired temperature.
7. Only press the START / STOP push-dial
once, firmly. Frothing has started once the
milk frother beeps once and the button
surround slowly flashes.
NOTE
Do not remove the milk jug from the power
base during operation. Doing so may
dislodge the frothing disc and cause a
grinding noise. Always press the centre of the
START / STOP push-dial before removing the
jug. Operation has stopped once the button
surround has stopped flashing.
