DOCUMENT SSE-0000077399-01 - V
61
–
Setting up recognition mode
T
ER
MI
NAL
C
U
STO
MI
ZA
TIO
N
T
ER
MI
N
A
L
C
U
STO
MI
ZA
TI
ON
T
ER
MIN
AL
C
U
STO
MI
ZA
TIO
N
T
ER
M
IN
A
L
C
UST
O
M
IZATI
ON
T
ERM
IN
AL
C
US
TO
MIZA
TIO
N
T
ER
M
IN
A
L
C
USTO
M
IZATI
ON
1. Setting up recognition mode
Two attempts mode
If the recognition fails, it is possible to give a "second chance" to the user.
In identification mode, if a bad finger is presented, the user has 5 seconds to
present a finger again. The result is sent if this period expires or if the user
presents a finger again.
In authentication mode, if the user presents a bad finger, he can replace his
finger without presenting his card again. The result is sent only after this
second attempt.
It is possible to set the finger presentation timeout and to deactivate this "two
attempts mode".
If the user is not identified, a second step follows immediately using a smarter
coding method. This coding allows recognizing users with dry fingers or
fingers with a bad placement on the sensor. However this coding is slower than
the light one.
Parameters
This mode can be configured using the Configuration Tool for example.
By default, the two attempts mode is activated.
The period between two attempts in identification (two attempts mode) can be
modified.
Setting up the number of attempts
app/bio ctrl/nb attempts 1 (only one attempt)
2 (two attempts mode)
Setting up the identification timeout
app/bio ctrl/identification timeout 5 (1-60)
Summary of Contents for MorphoAccess J-Bio
