25
A
PPENDIX
Time reset to 12:00
The base power was removed or base was reset :
If power was interrupted, the time will also reset or perform Default. Please set
the time again.
Replace or remove the batteries
D23 is in strange mode
Reset all the user-set features to the factory DEFAULT (refer to paragraph Re-
initialise the base, page 21).
D23 cannot make call
The base unit may not be correctly connected:
Ensure the base unit is correctly installed and connected. Make sure that the
power is On.
Other handset is already in communications (in multi handset user):
Only one internal or external call can be made at the same time. Ensure that
other handset is not already in communication prior to use.
Network Failure:
Try making a call from another telephone. If unsuccessful, contact your network
supplier.
If connected to PABX:
Make sure you have entered the correct PABX parameters in PBX feature of
D23.
Base Station does not function
Error in connection or lack of power supply:
Ensure that the Adaptor power supply has been connected to the D23 and the
adaptor is properly plug in to the AC power plug. Ensure that the AC power
should match the Adaptor AC voltage.
Make a power off / on reset of the base by removing and plug-in back the power
supply.
Handset does not function
Battery may not be installed correctly:
Ensure that the battery pack has been correctly installed. Follow the polarity
marking of the baterry and the drawing on D23 handset battery compartment.
Make sure the battery is fully charged, if not you need to charge it on the base
cradle.
If the rechargeable batteries are not being properly recharged, please change
them. In order to prevent any damage to your handset, only use rechargeable
batteries of the following type: NiMH 1.2 V 600 mAh AAA. Do not use non-
rechargeable batteries.
Registration fail
Wrong registration procedure:
Make sure that you know your D23 system CODE. If you are registering a new
handset to your D23 base, (refer to paragraph Registering a second handset to
a base, page 22). Try again if possible.
The handset displays "NOT
REGIST"
Your handset is not registered on a base, (refer to paragraph Registering a
second handset to a base, page 22).
Note: When the handset is not registered on a base, you can access only to the
REGISTRATION menu.
Inopportune ringing
When the messages in the voice box have been consulted, the message
presence indicators are turned off by the service provider. You may hear a short
beep indicating this function.
