INSTALLATION GUIDE
Page 28 / 46
3 000 068 637 éd04/ 542
4.
UNPACKING. PRODUCT CONTENTS
Carefully preserve the packaging of the EFT930.
It must be re-used whenever the terminal is shipped.
Packaging contains:
• PORTABLE itself, equipped with:
- its battery pack not connected,
- its paper roll;
• Base receiving the PORTABLE;
• Detachable power supply unit;
(the power supply unit delivered with your terminal is specially designed
for it. Do not use any other power supply.)
The use of a power supply having apparently similar voltage/current characteristics
may, in spite of it, damage your terminal;
• Telephone
cable;
• Installation
manual.
5.
BATTERY COVER FLAP
The battery cover flap is located under the portable.
Caution
:
Switch off the machine before opening the cover
.
5.1. OPENING
•
Turn the PORTABLE over on the table with the
bottom side facing up (figure opposite).
•
Unclip the cover flap by pushing on the clips with
your nails in the direction of the arrow 1 as shown
opposite.
•
Lift the cover flap on the clips side (arrow 2),
disengage the two rear limiting tabs from underneath the terminal housing and remove the
cover flap.
5.2. CLOSING
To close up the device, carry out the above operations in the reverse order.
•
Engage the two rear limiting tabs of the flap cover under the terminal housing;
•
Fold cover downwards to clip it on.
If a SAM stops the cover flap from closing, check the direction of its insertion.
•
Make sure the clips are totally engaged under the housing by pushing them manually.
