6-22
Maintenance
Date en cours : 22 mai 2001
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFK 23261430-5 36xx Sagem GB\Maintenance.fm
0
,6&(//$1(286
,1&,'(176
At switch-on nothing appears on screen
Check that the mains cable is plugged in, and check the mains plug if necessary.
The message
N
O
P
RINTER
is displayed.
Check that the power switch of the printer is in the I (On) position (refer to paragraph Printer
connection, page 1/12).
The fax does not detect the presence of your inserted document. The message
R
EADY
does not
appear on the screen.
At the start and during scanning,
R
EMOVE
D
OCUMENT
appears on the screen and the "On"
signal is red.
Remove the document or press key
.
Check the thickness of the document (30 sheets of paper of 80 g/m
2
).
Iron out the sheets if needed.
Help the sheets along.
The fax machine does not receive any faxes
Check that the telephone line cable is correctly plugged in and that there is a tone signal on the
telephone line.
• If the message
N
O
P
RINTER
is displayed on the screen, check if it is switched on, and check
that the printer connection cord is correctly plugged into the printer’s and fax’s jack.
You receive a blank page
Make a photocopy of a document ; if it is correct then your fax is functioning normally. Call back
the subscriber and have him resend the document. It was probably sent with the sheet inserted
backwards.
You cannot send a fax
Check that the telephone line cable is correctly plugged in.
+
Remove the jammed paper (B) without tearing it up.
+
Then, close the scanning cover of the sheet-feed scanner.
B
LIASSE 23261430-5.book Page 22 Mardi, 22. mai 2001 1:35 13
