Putting the device into operation
10 TELSAT
GPRS
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
3.3
Connecting the telecomms equipment
To put the device into operation you have to connect at least the power supply so that
the device gets power and one telephone to the
Phone
port, so that you can enter the
PIN number.
Power Supply
Connect the Power Supply adapter here. Use only the Power
supply adapter supplied with the
TELSAT GPRS
. Plug-in the
Power supply adapter into the mains socket.
RS232
Connect this interface with the COM port (serial RS-232
interface) of your computer, if you want to have access to the
internet or if you want to use your computer for fax and data
communication.
If you connect a device to the USB port, the RS-232-Port will be
deactivated.
Default settings:
Transmission speed
57,600 bps
Data
bits 8
Parity
N
(none)
Stop
bits 1
USB
If you want to connect your computer via its USB interface
instead of its COM port to the TELSAT GPRS, please first install
the drivers and then plug in the USB cable.
Phone
You can connect here analogue telephones. (Default for
incoming voice calls)
Fax/Modem/Phone
You can connect here analogue telecomm equipment, e.g.
analogue fax machine (Default for incoming fax calls), analogue
modem or analogue telephones
Power Supply
PC via RS232
Phone
PC via USB
Fax machine,
Modem, Phone
