Configuration
TELSAT GPRS
23
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
8 Configuration
Your TELSAT GPRS is a sophisticated device with a wide range of modes of
operation. You have to decide which operation modes are appropriate for your needs
and then enable them by configuring the TELSAT GPRS.
The configuration
process
Use a telephone connected to the
Phone
port or the
Fax/Modem/Phone
port of the TELSAT GPRS to enter a special
sequence (see below) just as you would dial a number. (The
telephone must use tone (= DTMF) dialling.)
The icons in the following descriptions mean:
listen to the confirmation tone:
a high pitched beep signals: OK
a low frequency beep-beep signals: Wrong entry.
You may have to wait 3 seconds before hearing the confirmation
tone.
lift up the handset.
hook on the handset.
ACCESS
means: access code; by default it is
000000
8.1
Access code for DTMF configuration
8.1.1
Changing the DTMF access code
The configuration of your TELSAT GPRS is protected against unauthorised
modification by an access code. The access code is part of each DTMF configuration
code apart from the DTMF codes to configure call forwarding.
The access code consists of 6 numeric digits. The default value is
000000
.
*5
OLDACC
023
NewACC
#
It means:
OLDACC
: old access code
newACC
: new access code
