Configuration
26 TELSAT
GPRS
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
8.3
Configuration of Network services
Depending on the GSM network you use and the subscription you have, there are
several services like Call Forwarding etc. available. You can activate/ deactivate these
services through the TELSAT GPRS. The configuration is stored by the network but not
by the TELSAT GPRS.
The configuration
process
Use a telephone connected to the
Phone
port or the
Fax/Modem/Phone
port of the TELSAT GPRS to enter a special
sequence (see below) just as you would dial a number. (The
telephone must use tone (= DTMF) dialling.)
The icons in the following descriptions mean:
listen to the confirmation tone:
a high pitched beep signals: OK
a low frequency beep-beep signals: Wrong entry.
You may have to wait 3 seconds before hearing the confirmation tone.
lift up the handset.
hook on the handset.
8.3.1
Call forwarding unconditional (CFU)
If
call forwarding unconditional
is activated incoming calls will be forwarded to the
configured telephone number. You can configure this for each type of call (voice, data,
fax) independently.
To change the setting enter the following sequence:
Description:
**21*
<Telnumber>
#
Activates for all call types
**21*
<Telnumber>
*
<call_type>
#
Activates for selected call
types (see below)
##21#
Deactivates call forwarding
unconditional
*#21#
Status Checking (see p.30)
