For experienced Users: AT commands
TELSAT GPRS
65
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
Command
Function
(factory setting in bold print)
ATV[
n
]
Set result code format mode. This parameter setting determines
the contents of the header and trailer transmitted with result
codes and information responses.
Parameters:
n
= 0 Information response:
<text><CR><LF>
Short result code format:
<numeric code><CR>
1 Information response:
<CR><LF><text><CR><LF>
Long result code format:
<CR><LF><verbose code>
<CR><LF>
ATZ
Load standard configuration
AT&C[
n
]
Set circuit Data Carrier Detect (DCD) function mode.
Parameters:
n
= 0 : DCD line is always ON
1
: DCD line is ON in the presence of data carrier only
(Default).
AT&D[n]
Set circuit Data Terminal Ready (DTR) function mode.
Parameters:
n
= 0: TA ignores status on DTR.
1: ON->OFF on DTR: Change to command mode while
retaining the connected call.
2
: ON->OFF on DTR: Disconnect call, change to command
mode. During state DTR = OFF is auto-answer off. (Default)
AT&F
Load factory setting
AT&k[n]
Local data flow control (DTE
$
DCE)
&k0
Data flow control OFF
&k3 Data flow control RTS/CTS
AT&V
Displays current configuration
AT&W Save
configuration
A/
Repeat previous command line
AT+FCLASS=
n
Setting the Faxclass
Parameters:
n
=
0
: normal operation
1: PC Fax enabled
AT+CGATT=
n
PS attach or detach
Parameters:
n
= 0 detached
1 attached
AT+CGDCONT=
APN
Define PDP context.
APN
= Access Point Name
AT+CPIN=
PIN
Enter the PIN number of the SIM card
