Configuration methods
TELSAT GPRS
81
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
15.1 Configuration by DTMF
The parameter values in
para.ini
may be changed by DTMF codes sent by a telephone
connected to the
Phone port
or the
Fax/Modem/Phone
port. The configuration by
DTMF is limited to those parameters the user may change most likely according to his
operation needs.
The inputs always have the following format:
*5
ACCESS
PAR
XXXXXX
#
Command ID
Access code
Parameter no.
Value
Save
*5
The command prefix informs the device that a configuration
setting is to be made.
ACCESS
The Access code (DTMF PASSWORD) protects your
configuration against intervention by others. Default: 000000
The command ID and the access code together ensure that
accidental incorrect inputs do not change your configuration.
PAR
You use the 3-digit
command ID
to specify which parameter you
wish to set.
XXXX
These digits (max. 6) set the new value for this parameter.
#
This character is the signal that the command ends here.
When entering DTMF tones using a connected analogue telephone correct entries are
acknowledged by an Accepted Programming Tone. If the input is incorrect you hear the
Non Accepted Programming Tone.
Example:
*5
ACCESS
001
15#
(sets in para.ini in section [DIALING] the parameter CHA_TX_VOICE_LEVEL to 15dB)
The table below shows the parameters that can be configured by DTMF codes. These
settings are described in chapter
Configuration
, page 23. The table shows the
command ID that is to be entered when using the telephone in order to set the
according parameter value. The table shows also the section and the name of the
parameters so that you can change the parameter settings by sending an SMS to the
TELSAT GPRS or by editing the
para.ini
file
