User Manual
23
does not stop, unless the modem is powered off and DSLAM or uplink
equipment is abnormal.
PPP IP extension:
If you want to configure DMZ Host, you should enable it
first.
Use Static IPv4 Address:
If this function is disabled, the modem obtains an
IP address assigned by an uplink equipment such as BAS, through PPPoE
dial-up. If this function is enabled, the modem uses this IP address as the
WAN IP address.
Enable PPP Debug Mode:
Enable or disable this function.
Bridge PPPoE Frames Between WAN and Local Ports:
Enable or disable
this function.
Enable IGMP Multicast Proxy:
If you want PPPoE mode to support IPTV,
enable it.
Step5
After setting the parameters, click
Next
to display the following page.
Step6
In this page, select a preferred WAN interface as the system default
gateway and then click
Next
to
display the following page.
