Glossary · RJ-11
67
EN
RJ-11
Registered Jack 11 (also called Western plug, stand-
ardised telephone plug)
Scanning
The reading of a document into the fax memory or
into the computer in order to send it, copy it or edit
it.
Sender Identification (= Header)
The telephone number and name of the sender as
well as the date and time of the fax transmission
appear in the upper margin of each received fax.
Sending to Multiple Recipients (= Broadcast-
ing)
With this function, you can send a fax message to
multiple recipients.
Telephone number suppression (CLIR)
If you call a subscriber, your number appears on the
display of the person whom you are calling. You can
switch off this function and suppress your number
(Caller Line identification Restriction, CLIR).
Time Stamp
The exact date and time of receipt appear in the page
header of each received fax. A memory buffer guaran-
tees that exact data are issued even after a power
loss. In this way, you can verify exactly when a fax
has reached you.
Tone Dialling (= Dual Tone Multi-Frequency)
In many countries, tone dialling has replaced pulse
dialling, in which each number was sent as a corre-
sponding number of pulses. With tone dialling, a
specific tone is assigned to each key (referred to as
DTMF tones).
Toner Level Memory
Your device registers the extent of toner used for
every print-out and calculates the toner level of the
toner cartridge on that basis. The toner level is
stored in each toner cartridge. You can use different
toner cartridges as well as display the respective
toner level of the toner cartridge.
Transfer Speed
CCITT/ITU has published international standards for
the transmission of data over telephone lines. All
short names begin with V, so these are also referred
to as V standards. The most important transmission
speeds for fax transmissions are: V.17—7.200 to
14.400 bps, V.21—max. 300 bps, V.22—max. 1.200
bps, V.22 bis—max. 2.400 bps, V.27 ter—max. 4.800
bps, V.29—max. 9.600 bps, V.32 bis—max. 14.400
bps, V.34—max. 33.600 bps
TWAIN
(Tool Without an Interesting Name) With the TWAIN
scanner driver you can access the device and scan
documents from any application which supports this
standard.
USB
Universal Serial Bus (computer port)
UTC
Coordinated Universal Time (UTC) Coordinated Uni-
versal Time is the current standardised universal
time used. Starting from Greenwich in London (Zero
Meridian), the world is split into time zones. These
time zones are indicated with a deviance from UTC
(in hours) for instance UTC+1 for Central European
Time (CET)
Warm-Up Phase
Normally, the device is in the energy saving mode
(see Energy Saving Mode). In the warm-up phase, the
device heats up the printing unit until it has reached
the necessary operating temperature, after which the
copy or fax can be printed out.
