- 119 -
MF 6990dn - Agoris C935
15 -
Safety
Safety
Safety Instructions
Before connecting your machine, check that the mains plug to which you are connecting the machine complies
with the indications on the information label (voltage, current, frequency of electricity network) on the machine. This
machine must be connected to a single-phase mains power supply. The machine should not be installed directly on
the ground.
Batteries, packaging and electrical and electronic equipment (EEE), must be disposed of in accordance with the
instructions in the ENVIRONMENT chapter in this manual.
Depending on the model, the machine's power plug may be the only means of disconnecting from the electricity
supply. As a result, the following precautions must be taken: the machine must be connected to a nearby power plug.
The power plug must remain easily accessible.
The machine is supplied with a mains power cable fitted with an earthed plug. An earthed power plug must be
connected to a wall socket fitted with an earth connected to the building earth protection.
For installation conditions and precautions for use, please consult chapter Installation [
9].
Laser Safety Information
CAUTION
: The use of controls, adjustments or performance of procedures other than those specified in this
guide may result in hazardous light exposure.
This equipment complies with international safety standards and is classified as a Class 1 Laser Product.
With specific reference to lasers, the equipment complies with laser product performance standards set by
governmental, national and international agencies as a Class 1 laser product. It does not emit hazardous radiation as
the beam is totally enclosed during all phases of customer operation and maintenance.
For Europe/Asia
This machine complies with IEC 60825-1:2007 standard, is classified as class 1 Laser Product and is safe for office/
EDP use. It contains one laser diode, of maximum power 15 milliwatts and and wavelength from 770 to 800
nanometres.
Direct (or indirect reflected) eye contact with the laser beam may cause serious eye damage. Safety precautions and
interlock mechanisms have been designed to prevent any possible customer exposure to laser radiation.
Repair-maintenance
: Have any repair and maintenance work carried out by a
qualified technician. It is prohibited for users to repair internal components. To
prevent all risk of electrocution, you should not conduct these operations
yourself, as by opening or removing covers, you are exposed to a double risk:
Irremediable injury may be caused to the human eye if it is exposed to laser
rays.
Contact with powered components may cause electrical shock with extreme-
ly serious consequences.
