Sagola CP1000, Instruction Manual

- Place the compressor on a horizontal and non 

sliding surface in order to avoid vibrations and 

movements.
- Install the compressor in a cool and well ventila-

ted area and with a temperature between 5 and 

40°C. Check that the voltage and frequency are 

compatible with the compressor, check the plug 

has a correct   ground connection.
- Before connecting the compressor, check that 

the mains voltage is adjusted to the electrical 

characteristics of the compressor.

- Observe and apply current standards and 

directives.
- In the CP2000 model, to preserve its durability, 

use rationally the switch in position II.
- Never leave the compressor exposed to dust, 

acids, vapors, flammable or explosive gases or 

elements (rain, sun, fog, snow).

1. With the electric socket disconnected, 

connect the air hose to compressor and 

airbrush.
2. Check that the compressor is totally depressu-

rized. Press the airbrush outlet valve and verify 

no air is coming out.
3. Connect the electric socket, check that the 

pressure regulator is closed, and turn on the start 

switch.

In the 

CP 1000

, the compressor starts when there 

is an air pressure less than 3 bars inside the 

tank, and stops automatically when it reaches 4 

bars. When the tank is full (approx. 100 

seconds), turn the pressure regulator until the 

pressure gauge indicates the desired working 

pressure.

In  the 

CP 2000

 model with the switch in position 

1 the compressor starts when there is an air 

pressure less than 3 bars inside the tank, and 

stops automatically when it reaches 4 bars 

(approx. 60 seconds). When the tank is full, turn 

the pressure regulator until the pressure gauge 

indicates the desired working pressure.
With the switch in position 2 the compressor is 

running continuously generating a maximum 

pressure of 6 bars (tank loaded about 180 

seconds).

IMPORTANT:

Before start working, check for air leaks. 
With the pressure gauge set at the desired 
pressure, turn the switch off and check that 
the pressure in the gauge is fixed. If the 
pressure goes down quickly, it means there 
is an air leak. Any small leak will affect the 
correct working of the compressor and the 
job quality.

- 16 -

5. START UP

4. ADVICE