Sagola HT10, Instruction Manual

In accordance with Directive 2006/42/EEC
Manufacturer:  

SAGOLA S.A.

Address:  

C/ Urartea, 6 ·  01010 VITORIA-GASTEIZ  (Álava) · SPAIN

Hereby declares that the product: 
Brand:  

SAGOLA

Product line:   

HT10/ HT15/ HT25  

It is in accordance with the Essential Safety Requirements set out in the Annex to Directive 

94/9/EEC.

For compliance with the requirements, the product complies with the standards:
- Directive of the EC Machinery (2006/42/EEC)
Also is in conformity with the provisions of the following Directives:
- ATEX regulation (Directive 94/9/EEC)      II 2G, IIB T3 X.
Marked “X” All static electricity is discharged by the air ducts. 
Air hoses should be 

"ANTISTATIC"

Also is in conformity with the provisions of the following Directives: 

UNE-EN-13463-1:2011, 

UNE-EN ISO 12100:2012, EN 809, EN12621, EN12162 and EN 1127-1.
The complete technical documentation and service instructions for the product are available.

In Vitoria-Gasteiz, on 01/01/2015   

Signed: General Director

-  23  -

Failure 

Cause of the failure 

Repair

The Product is not sprayed

The unit builds up too much 
pressure

There is product leak 
through the bellows 
(pneumatic components/ 
hydraulic components)
The air motor freezes too 
much

The unit is leaking air and 
produces a small number of 
cycles when purging

The product Filter is blocked
The Aircap is blocked
The purge valve is open or faulty
The anti-pulsation Filter is blocked
Unit disconnected from the air supply, air valve 
closed or air inlet pressure regulator closed

The outlet valve is dirty or damaged
The pressure regulator is damaged
Excessive pressure at the air supply

Deteriorated bellows

Use of the unit at higher pressures than is 
admissible
Untreated compressed air
The air Compressor generates too much 
humidity  in the compressed air
Insufficient air supplied. Inadequate air hose 
(small Ø or air inlet regulator not adjusted (set 
at zero)
Gaskets in poor condition
Pneumatic distributor damaged

Clean it or Replace it
Clean it and/or Replace it
Close it or replace it
Clean it or  Replace it
Connect the unit to the supply. Open the 
air valve or adjust the pressure regulator 
to allow air to flow.
Clean it and/or Replace it
Replace it
Do not exceed the maximum 
recommended work pressures
Replace the bellows

Check that the air inlet pressure 
regulator operates correctly
Install air filtering group
Purge the air Pressure Pot

Replace the air hose. Adjust the 
pressure Regulator and increase the 
pressure.
Replace them
Replace it

20. DECLARATION OF CONFORMITY